Surface Fixed Sonora
Installation Instructions

1. Carefully lay 2 x legs on a level surface and insert M8x120 bar and Counter Sunk Barrel nuts. Using packing box as protection lay instrument note side down on the card. Line up pre drilled holes in the backboard with the legs and ensure the instrument is aligned square with the legs. Fix in place using M8x30mm barrel nuts supplied (see installation guide).
2. Attach surface plates to each leg with M10x70mm and Barrel nuts supplied. (See Surface Fix Installation Sheet)
3. Fix Surface Plates to level surface using Coachscrews, Rawlbolts, chemical anchors or similar as deemed appropriate by Installer. (It is your responsibility to ensure that the existing surface is suitable to receive the appropriate fixing)
4. Make sure all fixings are covered and secure using cover caps provided.
5. Beaters can be fixed to Stainless Steel posts with fixings provided.

Surface Fixed Sonora
Instrument Components:

Sonora
M8 Barrel Nut x4
Eye Straps x2
M6x20mm Secure Screw x4
M8 CSK Barrel Nut x4
Pair Small Beaters x2
Surface Fix Components:
2 Part Cover Cap x8
M10 Barrel Nut x2
M10x70 Security Screw x2
Assembly Guide: Components List

Saddle Strap X2
M6x20 Pin torx X4
M10x70 Pin torx X2
M10 Barrel Nut Pin torx X2
M8 Barrel Nut Pin torx X4
M8 CSK Barrel Nut Pin torx X4
M8 x120 Stud X4

Spares available from percussionplay.com or from your local distributor.
Thread Lock Solution Required (not supplied).
Ground Anchors not supplied.
Surface Fix Post Installation

1. Locate the Surface fix
Plate into the leg of the
instrument.
2. Fix instrument to Surface
fix plate using M10 bolt
and Barrel Nut and use
thread locking solution
to prevent fixings working
loose.
3. Fix Surface Plate to the
ground surface Ground
Anchors Not provided
cover fixings with caps
provided.